RELIFE T-010 IP13 SERIES 4 IN 1 MIDDLE MOTHER BOARD TESTER

T-010 is device that solves the problems of repeated lamination and test trouble during the repair process, making the motherboard test simple and fast and it is suitable for IP13/13 Mini/13 Pro/13 Pro Max motherboard detection, test failure, boot, display, touch, camera, flash, photosensitive distance, earpiece, speaker, WIFI, face recognition, etc. This device is small and portable, easy to operate, and also has Precise measurement and positioning. Using 0.5mm high-quality pure copper probers, the conductivity is better, so that the motherboard is accurately connected. The material is excellent, and is also durable. 

Precise hole pitch design is presented here to ensure that the hole pitch accurately meets the standard test points. It is being manufactured in fine production technology, precise alignment, and strict screening. Avoid repeated heating and bonding test of the motherboard, which will cause the expansion of motherboard failures. As a result efficiency is being improved and maintenance risk is also reduced. 

The operation is simple, quick rebound and it has also time to time feedback. So, there won’t be any stuck. Bottom plate hollow design with non-slip feet helps in measuring the important voltage and signal of the baseband, and it is convenient and quick to repair the fault without baseband with no signal, and serial number.

Operation process schematic

To operate this device, one need to follow the below instructions: 

1. Place the lower layer of the motherboard in the corresponding position on the tester

2. Place the motherboard corresponding to the motherboard test pin board

3. Place the upper layer of the main board above the needle plate (the needle plate is limited)

4. By holding the cable one have to start the test.